ライブラリ登録: Guest
ホーム アーカイブ Thermal Letter 役員 今後の会合 国際伝熱会議の集会
International Heat Transfer Conference 16

ISSN: 2377-424X (online)
ISSN: 2377-4371 (flashdrive)

MODELING OF ACTIVE-CONTROLLED THERMOSYPHONS FOR WATER RECOVERY APPLICATIONS

Tao He
Department of Mechanical Engineering Stony Brook University, Stony Brook, NY 11794, USA

Wei Zhong
Department of Mechanical Engineering Stony Brook University, Stony Brook, NY 11794, USA

Sean Hardick
Stony Brook University, Stony Brook, NY 11794, U.S.A

Rebecca Trojanowski
Brookhaven National Laboratory, Upton, NY 11973, USA

Tom Butcher
Brookhaven National Laboratory, Upton, NY 11973, U.S.A.

Timothy Wagner
United Technology Research Center, East Hartford, CT 06108, USA

Yaroslav Chudnovsky
Gas Technology Institute, 1700 South Mount Prospect Road, Des Plaines, Illinois 60018, USA

William Worek
Stony Brook University, Stony Brook, NY 11794, USA; Texas A&M University-Kingsville, TX 78363, USA

Jon P. Longtin
Department of Mechanical Engineering, Stony Brook University, NY, USA; Center for Accelerator Science and Education, Stony Brook University, NY, USA

DOI: 10.1615/IHTC16.her.022884
pages 4761-4771


キーワード: Heat exchanger, Condensation, thermosyphons, water harvesting, natural gas combined-cycle power plant

要約

This study presents the concept of the active-controlled thermosyphon with polymer tube on the evaporator side for the recovery of water vapor in the flue gas of the natural gas combined-cycle (NGCC) power plant. The water vapor is condensed on the tubes shell side cooled by evaporation of the water liquid falling film inside the tubes, which is co-flow with the gas outside the tubes. The corresponding heat and mass transfer process was modeled by the ε-NTU analytical method. The results are discussed and compared with the lab-scale humid-air condensation experiment.

購入する $25.00 Check subscription 出版倫理および不正行為 私の図書館員へ推薦 このページをブックマークする